mysteries revealed

a friend/client stopped by to look at the walnut coffee table he had commissioned (in the post below), and we were looking at the x table. i didnt see the model at first, and so i showed him the blog post and realized that the joinery was still not clear from the photos ... after he left, i found the model, (right next to the table base, behind some cardboard), set it up, and took some more helpful pictures ... it should all be clear now ... in the end, you are gluing up two identical (except for the angles) ts, both with lag bolt reinforced joinery and large (2.75" x 2.75") long grain glue surfaces ... totally rigid. click the photos to enlarge them.
two ts are assembled individually ...
the tennons are glued and on the real base we used countersunk 4" timberlock screws to connect and reinforce the joinery for the half pieces. you can see at the top how the two ts intersect when they are assembled to create the full x.
glue up and level check ... perfect !! gold star for lorne ...
and here is the jig lorne used to cut the exact angles on the chop saw (55 degrees). the timberstrand was screwed to the wood fence to orient the 3" stock on the proper vertical for cutting the 55 degree angle where the oak meets the glass and the floor....
and, i noticed will had been by the shop yesterday to take the rubberbands off his fretboard glue up and install some frets in it.
and, this morning, i got an email from another client who will be stopping by shortly to check out this expanding table which well be delivering to them shortly ...

Related Posts by Categories