Pages

Minggu, 24 April 2016

More Half Round Stuff


Will put the inlays in the edges of the tops today ... He first sliced them with a thin kerf Makita 6" blade on the table saw, then sanded the edges slightly and in they went ..
First Will trued up the 8 degree angles with a fixed block on the edge sander ...
Brushed a coat of glue into the channel and taped them into place ... They are cut just thick enough to be raised from the surface of the edge of the table so the tape puts a little pressure on them. Hell sand them off in the morning and start finishing the tops. The bit is hard to find in your typical lumber yard but heres the number and maker .. click the picture to enlarge it ... Go to your favorite online router bit store and type in the name and number ...
Home stretch ... Drawers and finish ...

Related Posts by Categories

0 komentar:

Posting Komentar