Bench Build Next Steps

The bench build continues to go well, I have finished the parts for the front glide vise and I my goal is to get this installed and adjusted this weekend.

Glide vise parts

The parts above are hard maple, the chop was a challenge. It is 2 5/8" thick at the top and tapers down to 1 9/16". I tried to resaw the glue up on my band saw, but it was a struggle, so I stopped, got out the #40 scrub plane, the #6 jointer, and the #4 smoothing plane and had my workout for the day/week/month.
One thing I learned is that you can tap hard wood to accept machine screws. This may seem elementary to some of you, but I had never thought to do that before, and is suggested in the plans to do so.

bench view with leg attached

I went ahead and painted the unit, oiled the knobs and door stops and the bottom foot of the bench. The plan calls for a 4/4 foot I believe and I felt that would make the bench lower that I like so I used simple 2x4 and with the thickness of the top will put the height where I want it.  I can touch up any dings later. The finish is General Finishes Milk Paint Bayberry Green, hardware supplied in the Bench crafted hardware pack.

Additional bench view

The remainder of the work will be on the top and the tail vise. I have all the maple I need barring any major screw ups, and I had to use hard vs. the preferred soft maple. My wood monger in Indiana did not have a good selection of clear soft maple so rather than wait I switched to the hard maple.